Product Review: Eduard Masks

 

 There are all sorts of tools and supplies in the modelling hobby, and it’s a fair criticism to ask if the modern hobbyist is well-served or merely gadget-dependent. When we need to mask something we use tape, like any tradesman, plus cut paper and card sections for big areas, and we may also use a liquid latex masking medium, an aid brought over from the graphic arts. I always masked my canopies with tiny slivers of tape, but there are some curved that just don’t want to be masked around. A three dimensional shape needs to be expressed in two dimensions, and that’s a hit or miss proposition unless you’re a spatial dynamics expert. Another trick is to spray the hull color on some clear decal film, cut fine strips and apply the canopy struts as decals, and there’s a lot to be said for that technique. There have been a few ideas over the years, including precut vinyl negative masks which are to be sprayed in the final colour and applied, but Eduard might have hit the best formula with their masking technology. Eduard Masks are die-cut adhesive shapes matched to the intended kit at very fine resolution, and the principle of their use is dead easy: peel them off their waxed backing paper, stick them on, spray, peel off when done. If engineering firms go by the old “KISS principle,” (which stands for Keep It Simple, Stupid!), then they’ve probably hit the money. If the hundreds of sets in their range are anything to go by, modellers agree. 

 I’ve used four sets so far and have several more in hand. Though the principle is simple, it takes a fine hand and a keen eye to get them into place precisely. Without magnifying specs I’d have no hope, though that’s more a comment on my vision than the product. The masks seem to be a vinyl or paper material, and their adhesive is quite strong, they won’t move until you want them to, and then they come away without leaving a residue. They can be repositioned, though with care as they will crease and denature if handled roughly. They fully cover smaller panels and outline larger areas, which are then filled in with liquid or tape.  

 Once located to your satisfaction, spray the cockpit interior colour, then overcoat with the camo or framing colours, and when fully dry tease up a corner with the point of a knife and draw the masks away with tweezers. You might also want to hold the canopy down with a finger as you do so. The adhesive is strong enough to pull a clear part off if attached only with clear parts cement.  

 Masks are also supplied for other parts of the model, such as wheel rims and formation lights, and some armour sets have been produced to help with the fiendish job of painting the tires of tank wheels. Hopefully we will see this range continue to grow, as their utility is considerable. Can you re-use a set? I’ve not tried yet, but if you peel them off carefully and return them to their original positions on the backing sheet, it might be possible. Two uses would be good, as they do cost a few dollars, a nonreimbursable expense on the cost of doing a model which is far greater than that of the paint one uses, and often comparable to that of a selection of AM decals. Probably the best tribute I can pay to the product is that when I decide a particular model is on my schedule, I check if Eduard have masks for it and order them up in plenty of time, just as I would order AM decals or resin bits or whatever, and that makes them a tool of choice for this particular finishing operation. I recommend them to any hobbyist with a steady hand and a magnifying glass. Eduard Masks are available in hobby shops and through many online outlets, I always order mine from Squadron Mailorder, Carolton, Texas.